Tray cleaning materiar : AL Remover
AL Remover is a liquid tray cleaner that shrinks alginate impression materials, allowing it to be easily
peeled off.
It does not dissolve the alginate impression materials, enabling fast processing.
It leaves no residue, has a long lifespan, and also offers antibacterial properties.
Applications
Tray cleaner for removing alginate impression materials (liquid)
Features
- Fast
- It removes the alginate impression materials by shrinking it without dissolving it, allowing for quick removal.
- Easy
- It can be used as lasts long without getting dirty.
- Clean
- Since it does not dissolve the alginate impression materials, no residue is left, and it has antibacterial properties.
Packaging Unit
- 2000ml
Usage Instructions
- Transfer the liquid directly to a container.
- Fully immerse the tray with the alginate impression materials in the liquid.
There is no need to remove the alginate impression msaterials from the tray in advance. - Based on the standard processing time, remove the tray from the liquid (refer to Table 1).
- Immediately remove the alginate impression materials from the tray and rinse it with running water.
- If white sediment appears in the liquid or if the entire liquid becomes white and cloudy, please replace with new liquid.
- Soaking the tray for a long time each time will shorten the solution’s lifespan.
- Depending on the type and condition of the tray, it may discolor or corrode.
- Processing at temperatures above 40℃ may cause the tray to discolor.
| Standard Processing Time | SSS New Alginate | |
|---|---|---|
| Mesh Partial | 15-30 minutes | 15 minutes |
| Mesh Regular | 30-60 minutes | 30 minutes |
| Perforated Partial | 45-75 minutes | 45 minutes |
| Perforated Regular | 60-90 minutes | 60 minutes |
| Solid Partial | 75-105 minutes | 75 minutes |
| Solid Regular | 90-135 minutes | 90 minutes |
- The processing time varies depending on the type of alginate impression materials.
- For paste types where gypsum is mixed, use approximately two-thirds of the processing time of SSS New Algistar as a guideline.
Video
Related Products
-
- Can it be used with any impression material?Open
-
It can be used with general alginate impression materials.
For some products (mechanical paste-type impression materials), please use a dedicated remover.
-
- Is it okay to immerse for a long time (such as overnight)?Open
-
Long-term immersion is not recommended as it may reduce effectiveness and damage
the tray.
It is recommended to remove it within the standard processing time (30 minutes for single arch trays, 1 hour for full arch trays).
-
- Will it damage the tray?Open
-
Metal trays may discolor or corrode.
However, compared to dissolving-type tray cleaners, the risk is lower due to shorter immersion times.
-
- What is its processing capacity?Open
- AL Remover can process approximately 660 single arch trays or 300 full arch trays per 2 liters.
-
- When should it be replaced?Open
- Replace when it becomes cloudy. (Processing speed will decrease due to reduced effectiveness)
-
- How should the used liquid be disposed of?Open
- As it is a cleaner based on citric acid, consult your contracted industrial waste disposal company for disposal.
-
- Is the liquid acidic or alkaline?Open
- It is mildly acidic.
-
- What are the benefits compared to powdered cleaners?Open
-
It is easy to use as is.
By shrinking and peeling off the impression material, the liquid stays clean and can be used hygienically without the need for post-treatment.
-
- Does the temperature of the liquid affect its effectiveness?Open
-
Lower temperatures reduce processing effectiveness.
Approximately 25℃ is the most effective.
Be cautious as temperatures above 40℃ may accelerate tray damage.